Things you will need:
- Flat sheet of plastic
- Scissors
- Hole punch/Drill
- Fishing line
- Suction cup
- Sea weed
Step 1:
Take a flat sheet of plastic and cut out 2 squares roughly 5x3 inches with a tab at the top.
Step 2:
Take one piece of plastic and drill/punch multiple holes roughly 1/4 inch apart, in a grid pattern.
Step 3:
Cut two small holes into the bottom of both pieces of plastic and one hole I the tab. The hole in the tabs will be used to clamp bot sheets of plastic together as well as hold the suction cup.
Step 4:
Use fishing line to tie the two pieces of plastic together.
Step 5:
Insert the stem of the suction cup into the hole of each tab at the top of the plastic to ensure a proper fit. Once everything is right, insert a piece of seaweed and begin feeding your herbivores.
- Flat sheet of plastic
- Scissors
- Hole punch/Drill
- Fishing line
- Suction cup
- Sea weed
Step 1:
Take a flat sheet of plastic and cut out 2 squares roughly 5x3 inches with a tab at the top.
Step 2:
Take one piece of plastic and drill/punch multiple holes roughly 1/4 inch apart, in a grid pattern.
Step 3:
Cut two small holes into the bottom of both pieces of plastic and one hole I the tab. The hole in the tabs will be used to clamp bot sheets of plastic together as well as hold the suction cup.
Step 4:
Use fishing line to tie the two pieces of plastic together.
Step 5:
Insert the stem of the suction cup into the hole of each tab at the top of the plastic to ensure a proper fit. Once everything is right, insert a piece of seaweed and begin feeding your herbivores.